All Activity
-
Ccolemj replied to the thread Using only one shore power cord.If you only need 30A service, then one cord will suffice. The problem on many boats is that the dual 30A cords feed different branch...
-
BigEasy replied to the thread S1 Wheel Pilot conversion.Presently have a Raymarine Evolution 100 wheel pilot including P70s control head, 4000st wheel & drive motor, EVO 100 ACU (autopilot... -
jdhohmann replied to the thread S1 Wheel Pilot conversion.I did!!. We built a metal bracket to enable us to get worm drive up to height of steering quadrant. I have never had any problem and... -
kloudie1 replied to the thread S1 Wheel Pilot conversion.I don't know for sure, but the S1 power switched supply to the motor drive may not be able to handle the higher amperage draw of a below... -
rpwillia reacted to dlochner's post in the thread Holding tank and water tank under V berth sending units with
Like.
The Gobius C mounts to the top of the tank, connects to a NMEA 2000 network and has Bluetooth LE. Pricey, but a lot of features. Also... -
rpwillia replied to the thread Is it possible to leak coolant from the raw water pump/engine block union?.If it is Coolant the Sherwood (or Oberdorfer if you upgraded yours) is not the problem. There is a pump that moves the antifreeze around...
-
Ddlochner replied to the thread Holding tank and water tank under V berth sending units.The Gobius C mounts to the top of the tank, connects to a NMEA 2000 network and has Bluetooth LE. Pricey, but a lot of features. Also...
-
rpwillia replied to the thread 310 primary anchor.One time my Manson dragged, but reset. Only learned later why .. what are the odds.
-
-
Has anyone converted their S1 Wheel Pilot to a below deck drive? If so, what did you use and how did you mount it? Is it just a straight...
-
rpwillia replied to the thread Holding tank and water tank under V berth sending units.I like the idea of the stick on sensors on the side, but do not want another display, and my Axiom can show tank levels via nmea2000...
-
Alan Gomes replied to the thread Honda 2.3 HP. I give up..I did that technique diligently, and it worked great--until it didn't. I still do that, by the way, even though I am running True Fuel... -
twodzusfittings replied to the thread Honda 2.3 HP. I give up..In order not to gum up the carb, when I am done using it, I always shut off the fuel and run the carb dry. Then store it on board my... -
rpwillia replied to the thread Using only one shore power cord.I keep a 50 to 30 adapter on my boat ( I only have on 30 amp connector on my boat) which is handy when the only slip available has a 50...
-
Ddlochner replied to the thread Unable to login on my phone.....When you login choose the option to "stay logged in" this by passes the ads and it is not necessary to login each time.
-
thinwater replied to the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape.Good point. On weather surfaces, the same principle applies. You do not want water hiding inside the wall. Better that it drips through.
