All Activity
-
Ddlochner replied to the thread Holding tank and water tank under V berth sending units.The Gobius C mounts to the top of the tank, connects to a NMEA 2000 network and has Bluetooth LE. Pricey, but a lot of features. Also...
-
rpwillia replied to the thread 310 primary anchor.One time my Manson dragged, but reset. Only learned later why .. what are the odds. -
-
Has anyone converted their S1 Wheel Pilot to a below deck drive? If so, what did you use and how did you mount it? Is it just a straight...
-
rpwillia replied to the thread Holding tank and water tank under V berth sending units.I like the idea of the stick on sensors on the side, but do not want another display, and my Axiom can show tank levels via nmea2000...
-
Alan Gomes replied to the thread Honda 2.3 HP. I give up..I did that technique diligently, and it worked great--until it didn't. I still do that, by the way, even though I am running True Fuel... -
twodzusfittings replied to the thread Honda 2.3 HP. I give up..In order not to gum up the carb, when I am done using it, I always shut off the fuel and run the carb dry. Then store it on board my... -
rpwillia replied to the thread Using only one shore power cord.I keep a 50 to 30 adapter on my boat ( I only have on 30 amp connector on my boat) which is handy when the only slip available has a 50...
-
Ddlochner replied to the thread Unable to login on my phone.....When you login choose the option to "stay logged in" this by passes the ads and it is not necessary to login each time.
-
thinwater replied to the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape.Good point. On weather surfaces, the same principle applies. You do not want water hiding inside the wall. Better that it drips through. -
jssailem reacted to kappykaplan's post in the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape with
Helpful.
This is on his house, not his boat. -
Ha! Thanks. I was spoiled by my old sail. All i had to do was turn into wind and back the headsail. Different conditions didnt seem...
-
The air was light so i had the jib car forward pulling down on the leech, and the jib a bit let out to fill it (baggy) sort of like you...
-
kappykaplan replied to the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape.This is on his house, not his boat. -
thinwater replied to the thread Unconventional Deck Fuel Fill Installation and Bed-It Tape.If it is through-bolted, butyl should be all the sealant you need. Clean up the squeeze-out with a plastic knife or similar. It is NOT...
-
Yuxian replied to the thread Help with "Leben ist gut".Thank you, both, for your input on this subject. At our age it's difficult to answer how long we might spend underway, though, I think... -
