All Activity
-
Ddlochner replied to the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve.As @Ralph Johnstone mentioned there needs to be an electrical connection between the anode and the hose barb to complete the circuit...
-
Don S/V ILLusion replied to the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve.When I used to winterize the A/C on our Hunter, I would suck antifreeze through the hose attached to that thruhull which was the only... -
Ralph Johnstone replied to the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve.As per above, inferior metallurgy is the most likely cause of the early failure of the barbed fitting. Kind of hard to tell what the... -
jssailem reacted to Inter20sailor's post in the thread Use Raritan Joker valve in Jabsco? with
Like.
Thank you all for the intel. Ordered! Fair winds to all….. -
You can usually drive sailors off with a good snap from a wet bath towel.
-
IInter20sailor replied to the thread Use Raritan Joker valve in Jabsco?.Thank you all for the intel. Ordered! Fair winds to all…..
-
Justin_NSA replied to the thread Any hope for instrument display 'burn-in'?.Instrument is boxed and ready to ship tomorrow! Carefully marked where all the wires plug in! Thanks again for the tip!! -
Ccolemj replied to the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve.It is very common for people, and even boat builders, to use hardware store barb fittings on thruhulls. Often, these will be brass and...
-
DDean Strong posted the thread Corroded Dezincified Hose Barb on Raw Water Intake Ball Valve in Ask A Hunter Owner.I recently discovered the hose barb threaded into the raw water intake ball valve was almost gone. The hose got bumped while changing...
-
shemandr replied to the thread Exterior wood hand rails.What kind of headliner does the OP's boat have? That determines a lot about how big the job is. -
Ralph Johnstone replied to the thread Exterior wood hand rails.Always have to start with pictures unless someone with the same boat replies. Post photos and we'll tell you what you're looking at...
-
-
SHi I have a 1990 Hunter 35.5 and I am thinking of removing the wood hand rails on the deck and either replace with metal or refinish Is...
-
Ralph Johnstone replied to the thread Saw this on the web..You can usually drive sailors off with a good snap from a wet bath towel.
-
If you have been to Blake Island, then you know this is true. -
jssailem reacted to Joe's post in the thread New Owner // 1983 Hunter 27 // Running Rigging Questions with
Helpful.
You don't have to take down the mast to replace your existing halyards. Adding new ones will require taking down the mast or going up...
