All Activity
-
jssailem replied to the thread Furler Q’s.Ok. what if you were able to ass the length to the base? part B32 is the “Toggle Fork Fork”. If is was 2” longer that would lengthen... -
-
fred1diver replied to the thread Start button.Ok, thank you very much, I was looking at the same one on Amazon last night. I need to refresh on my electronics and electrical... -
fred1diver replied to the thread Furler Q’s.This is the only picture I have, it was taken before I undertook the whole furler task this spring, Basically a thick pin goes through...
-
-
geoffschultz posted the thread Victron MultiPlus not charging after generator capactor blew in Ask All Sailors.I'm on my way from South Africa to the Newport, RI area and just arrived in Bermuda. I have a NextGen UCM 9.5 generator, and the other... -
All depends on the draw of your starter relay. Now is the time to place a series ammeter at the current push button starter and see...
-
Ralph Johnstone replied to the thread Start button.All depends on the draw of your starter relay. Now is the time to place a series ammeter at the current push button starter and see... -
jssailem reacted to colemj's post in the thread Galvanic Corrosion/zinc depletion question. with
Like.
50Hz vs 60Hz makes no difference. As stated, AC current has little impact on stray current corrosion. If the culprit does happen to... -
Definitely the better way to go and avoid an additional relay (the booster relay) if you can get anywhere near the wiring. I'm retired...
-
Small clarification.. After looking at the Yanmar wiring, and doing a little research on wire size etc, I decided to feed the key switch...
-
jssailem replied to the thread Furler Q’s.Pictures are needed. How is the forestay attached? Which furler do you have? My rig uses a tang that can be adjusted by size desired...
-
-
Seems to have happened on both sides of the border.
-
This is an issue for my type of sailing - lake sailing. The next fill up is years from now. I do not motor long/far enough to burn much...
-
Engine mounts only last about 1000 hrs, then require replacement. They are likely due. As for the engine quitting, there can be many...
-
Hayden, the link that I provided was simply intended to identify where pump out stations are located on coastal BC. It would be ideal... -
Richard19068 replied to the thread Cabin top hand rail.Thank you. Oil would be the way to go with that I guess Did you sand off the non skid before applying the Seadek?
