All Activity
-
And we are off to start of the 2026 Season. Jim... -
-
Oodaydokay replied to the thread Overheat adventure on 1985 Universal M12.Yes, I always have one of those babies ready to go. Never leave home without it right?
-
Sure, but resting in a partial state of charge with lead acid batteries increases sulfation and causes capacity loss. A good battery... -
FastOlson replied to the thread Re: 1984 Hunter 27 - Bow Damage.When I wanted a strong backing plate for a new bow anchor roller frame, I used some quarter inch G10 set into epoxy mush. Working... -
If you are going to replace the sheaves, in my opinion, you likely have other tasks that need inspection and refurbishing on the mast... -
If you are going to replace the sheaves, in my opinion, you likely have other tasks that need inspection and refurbishing on the mast... -
If you are going to replace the sheaves, in my opinion, you likely have other tasks that need inspection and refurbishing on the mast... -
Did you mean RIGID boom vang? Call Garhauer. -
jssailem replied to the thread Hunter 37.5 rigged boom vang.If you are going to replace the sheaves, in my opinion, you likely have other tasks that need inspection and refurbishing on the mast...
-
Stu Jackson replied to the thread Hunter 37.5 rigged boom vang.Did you mean RIGID boom vang? Call Garhauer.
-
jssailem reacted to BigEasy's post in the thread HUNTER 340 Yanmar 3GM Engine Mounts... OUCH! with
Helpful.
Original Yanmar mounts are definitely NOT stainless steel. Also note the hardness rating stamped into the side of the rubber... -
Hey sailors! Reaching out to the group to ask what brand and size the Hunter 37.5 uses. I also need to replace the sleeves at the top... -
kloudie1 replied to the thread Water in the Bilge.To (maybe) get the water out for winter, try imitating motion of sailing while on the trailer.. Try tilting the trailer up and down... -
Probably rain water. If you are near salty water you could always go on another cruise and then taste the water in the bilge and see...
-
If you are applying Cetol over wood that is epoxy coated, that may be your problem. I have found that not all varnishes, for example...
