All Activity
-
So dynamite it is. -
Joe replied to the thread New Headsail Adjustments.If I were you I'd contact Rolly Tasker and tell them your sail is too big. It doesn't fit... the vertical hoist is incorrect... -
kloudie1 replied to the thread Water in the Bilge.Welcome to the forum, Jim! Lots of good info here especially in the parts labeled "Owner Resources" and other "click on" sections... -
Oodaydokay replied to the thread Overheat adventure on 1985 Universal M12.Terrific, Richard. Many thanks. I had the coolant pump replaced two seasons ago at the very end and last year I did see some temperature...
-
jssailem replied to the thread Water tanks location.If the sensor is functioning you can measure the electrical resistance with a digital voltage meter using the Ohm meter function. This... -
The foot of most general purpose jibs is below the lifeline at the tack. This allows for a larger sail and more power. Some sailors have... -
Too much scalloping on the luff of the sail, which is why we're questioning if the sail is fully hoisted. Looks like the luff is too...
-
It looks to me like the sail needs halyard tension. Is the top of the at the sheave or stopper? If so, I think it may be too long...
-
Ddlochner replied to the thread Hunter 25 2006 - improve secure mooring.I bought a similar product to protect the coaming from the roller furling line. I think I purchased it from the SBO store. Something...
-
Eeast coaster replied to the thread Hunter 25 2006 - improve secure mooring.There is a product I purchased some time ago for this purpose of protecting my hull from line chafe. The name escapes me but there...
-
-
Several possible explanations. The hose is clogged and water can't get through. It is normal behavior. The common bilge pumps in our... -
Or a ShopVac.
-
Sunbird22358 replied to the thread Sink Water Supply.In theory, there should be 3 connections on the tank. 1) the 1.5" would be for a deck-fill (or if you have access to the tank and htis... -
-
BigEasy replied to the thread HUNTER 340 Yanmar 3GM Engine Mounts... OUCH!.Original Yanmar mounts are definitely NOT stainless steel. Also note the hardness rating stamped into the side of the rubber...
-
For a finish, a mechanical bond is enough. After all, nobody blinks twice at painting an epoxy repair, but for some reason gelcoat over...
