All Activity
-
As noted in the tables paragraph - Time: "All times used in these tide and current tables are Standard Times and based on the 24 hour... -
JJschen01 replied to the thread Barlow Furler refurbishment.Right - not paying attention when I was typing.
-
I about to dig into a starboard bulkhead replacement project on my boat, (Catalina 310, Hull 018). Does anyone have a photo of the... -
shemandr replied to the thread Aft cleat for Jib Sheets?.I don't think I would use Spinlock PXR's on sheets. I've seen them used for halyards, especially on the mast to jump the halyards... -
shemandr replied to the thread Quick Question About SBO Site Access.I'm so obsolete...
-
kappykaplan replied to the thread Barlow Furler refurbishment.Looks like a winch! -
JHi my Barlow furlers have both had the plastic ring at the top crack. Other than that they work well. Any way to get replacement rings...
-
-
GI am looking to buy one Lewmar Portlight Flyscreen with dimensions about 11 3/4 inches by 5 inches gray for my 2006 Hunter 38. I think...
-
-
shemandr replied to the thread R2AK (Race to Alaska).Thanks! The OceanConnect helped. It's a nice arrangement of information. I have to put some Canadian charts in my Open CPT. I may...
-
Anyone know where I can buy a replacement of this overhead cockpit speakers/light? This has seen enough. Thanks. -
-
JHas anyone had to refurb the water lines to the sink from the tank and from the drain to the through hull? Looking to confirm some...
-
-
shemandr replied to the thread R2AK (Race to Alaska).Thanks! Both are useful. It would help if I knew the geography better. But in poking around in Open CPN, imaps, the “Official” Chart...
-
fred1diver replied to the thread Furling system.I emailed them yesterday, I will wait to see what they say -
Ccolemj replied to the thread Quick Question About SBO Site Access.Starlink reports it as New Zealand. I am not in New Zealand, but that must be the closest ground station to French Polynesia. Mark
-
Ccolemj replied to the thread Furling system.I admit that was a guess, but it was much faster than I expected. I just looked at the order and I paid for it on May 12, it was...
