All Activity
-
You will want to examine the outside. It appears in the image that the outer rim is threaded onto the port that extends through the... -
jssailem replied to the thread Portlight removal / rebedding.You will want to examine the outside. It appears in the image that the outer rim is threaded onto the port that extends through the... -
Try a heat gun to soften old caulk. Use a thin blade putty knife to open a gap between the port frame & gelcoat. Continue applying...
-
Ccolemj replied to the thread Anchor chain corroding after 2 years.Sigh. Blame the victim. As I mentioned earlier, in the first case, ACCO admitted it was their chain, admitted it had failed, and...
-
jssailem replied to the thread Hard top dodger.SO True. :biggrin: Have you considered one of the many anchor alarm systems on chart plotters, phones, pads, or tablets? I have used...
-
BigEasy replied to the thread Portlight removal / rebedding.Try a heat gun to soften old caulk. Use a thin blade putty knife to open a gap between the port frame & gelcoat. Continue applying...
-
jssailem replied to the thread Adding a valve to the black tank outlet.A couple of questions. The RV valve makes me cringe if it is to stop raw water from entering the boat. I have seen those valves on RVs...
-
-
Terry Cox replied to the thread Water tank vents.Good morning, Fred. Defender has a tank vent suitable for water tanks here: https://defender.com/en_us/sea-dog-gas-tank-vent-352100-1 -
Hayden Watson posted the thread Adding a valve to the black tank outlet in Marine Plumbing and Sanitation.I am looking for feedback on my plan and suggestions for sanitation fittings. FWIW, I also have a motorhome and have concidered using a... -
Allan12210 replied to the thread H49 oven range hood fan replacemment.I was looking at Amazon. They have quite a few replacement exhaust fan blades. Some are aluminum, some are plastic and some have a set... -
hello all. I am looking to replace my water tank water tank vent. but I must admit I am having a hard time finding one, originally our... -
Stu Jackson replied to the thread Cetol.Have you considered reading the manufacturer's application instructions? -
Maine Sail replied to the thread Best 4 PIN thru-deck electric connection for mast?.I prefer Deutsch DTP. You just need the right crimp tool. Deck Side - DTP04-4P-L012 Mast Side - DTP06-4S-E003 -
fred1diver replied to the thread Cetol.I haven’t had a chance to try again varnishing the wood, but my next question is simple, what measure should I use to make sure the...
-
JoeWhite reacted to Allan12210's post in the thread Hunter 41DS prop shaft to gearbox key way falling out with
Like.
If you can tap it back in flush then install a stainless steel split collar on the shaft. Available from Amazon in the correct diameter...
