All Activity
-
Ccolemj replied to the thread Cotter Pins vs Cotter Rings....Trust the cotter pin. Bend it 20* or so. The reason not to bend more is because the work hardening weakens it. And there just isn't...
-
Hayden Watson replied to the thread New windlass for Papillon..The VX1 comes with the sensor preinstalled but I need to find the display without paying the extorsion from Lewmar. I am thinking... -
Ddlochner replied to the thread What is the purpose of this plumbing setup? (3-way connection under the sink).That is correct, and I have one in Second Star. I was suggesting a more frugal solution with the Super Sub pump. Both good pumps.
-
One life chapter finishes, and a new chapter begins. Fair winds. Be not a stranger. Alan & Eileen -
Davidasailor26 replied to the thread Cotter Pins vs Cotter Rings....I haven’t had a swing keel like that, but in many years of sailing I’ve never had a cotter pin on standing rigging turnbuckles fail. I’d... -
Davidasailor26 replied to the thread What is the purpose of this plumbing setup? (3-way connection under the sink).Or a self-priming diaphragm pump that can be mounted remotely, like the Whale Gulper -...
-
Dalliance replied to the thread 1978 H30 Shaft Removal/Rudder.There‘s no hole for an anode in my original strut. I just use prop shaft anodes. Magnesium in my case for fresh water. Hope the strut... -
Ddlochner replied to the thread What is the purpose of this plumbing setup? (3-way connection under the sink).It is a fairly common practice to route several drains through one through hull. In your case, I suspect there was an electric bilge...
-
Dalliance replied to the thread Fuel filter and sea strainer relocation?.My primary fuel filter was originally located in the engine compartment behind the engine. I moved it forward of the engine where it’s...
-
jssailem replied to the thread resignation.One life chapter finishes, and a new chapter begins. Fair winds. Be not a stranger. Alan & Eileen -
jssailem replied to the thread New windlass for Papillon..You might consider installing an anchor counter. While not a perfect solution, I am guessing they could be accurate to within a couple...
-
I fully agree that you need to be at the bow to retrieve the anchor. In my case, I will need to handle the nylon rode into the aft...
-
I don't think a remote switch for the windlass at the helm is a very good idea. The anchor below was fouled in the chain about half way...
-
jssailem replied to the thread Hunter 336 gelcoat repair.Oh come now Ralph. You know you could appreciate Oyster Shell White.
-
jssailem reacted to CABixler's post in the thread Mast mounted plastic resin halyard cleat for jib replacement? with
Like.
Thanks to all!! I did find exact replacement at US Spars. Easy webpage to look up. Resin was $17 but Aluminum Anodized was $30 so went...