All Activity
-
Stu Jackson replied to the thread Pre-launch diesel maintenance questions.WAIT!!! That petcock appears to be on the heat exchanger. If so, then you need to leave the petcock alone because all it drains is... -
quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the... -
jssailem reacted to kloudie1's post in the thread Pre-launch diesel maintenance questions with
Helpful.
quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the... -
Ddlochner replied to the thread Pre-launch diesel maintenance questions.Once upon a time I had a Volvo MD7A diesel with a similar problem. After dutifully paying an exorbitant amount for an official Volvo...
-
Change it pre haul out or after winter lay up; in either case, run engine for 5 minutes or so to heat the oil. At some point you’re... -
kloudie1 replied to the thread Pre-launch diesel maintenance questions.quick note: The threads in the nut to be removed are the usual "right handed" threads .. (Unscrew from block in usual direction) But the...
-
@JamesG161 beat me to it. I've used Rustoleum with great results.
-
jssailem reacted to Maine Sail's post in the thread Crimp Heat-Shrink Terminals Like a Pro, On a DIY Budget with
Like.
Links can be found here or by clicking "more " in the YouTube video. Crimp Heat-Shrink Terminals - Marine How To -
jssailem reacted to Davidasailor26's post in the thread Old ST60 with new transducer: wind speed is reading quite high. with Like.
I guess I’ll call you a heretic:poke:;). I can think of a few reasons you’d want to know the wind speed at all: (1) measure your...
-
jssailem reacted to Davidasailor26's post in the thread Old ST60 with new transducer: wind speed is reading quite high. with Ha.
I guess I’ll call you a heretic:poke:;). I can think of a few reasons you’d want to know the wind speed at all: (1) measure your...
-
jssailem replied to the thread Sizing of exhaust lines and water lift mufflers.You're in Seattle? Fisheries Supply would be a good source. Lots of brands. I have also used Seattle Marine & Fishing Supply on W...
-
jssailem reacted to rgranger's post in the thread Pre-launch diesel maintenance questions with Like.
Wrench here... Some PB blaster and a wire brush first to clean it up... let it sit a while then knock it with a wrench and a...
-
john6206 replied to the thread Pre-launch diesel maintenance questions.Sounds like the consensus is to change the oil after launch. I get a week in the slip before they kick me out. Even if my best weather... -
jssailem reacted to kappykaplan's post in the thread Are you aware of ths FCC action. Is your on-board router approved? with Like.
From farther down in the document: "The FCC is explicit: existing routers are completely unaffected, no action required. Firmware and...
-
jssailem reacted to rgranger's post in the thread Are you aware of ths FCC action. Is your on-board router approved? with Like.
Thanks for the info.... but it looks like existing routers are grandfathered in... to quote the first line of the article... "The FCC...