All Activity
-
HHelloOutThere replied to the thread H34 Engine angle iron replacement.I removed the starboard stringer last fall and milled a new stringer. The original stringer is raw angle iron 4x3.5x24x0.25. The aft end...
-
-
SailormanDan reacted to Dalliance's post in the thread Deck top clutches, organizers, winches with
Helpful.
The raised areas for deck hardware mounting might have aluminum plate laminated under the fiberglass for drill and tap hardware... -
Stu Jackson replied to the thread Sizing of exhaust lines and water lift mufflers.You do not have a unique engine. Call the manufacturers of those mufflers, tell them the lengths between the engine, muffler and... -
jssailem replied to the thread Electrical panel rebuild.Been there and have done the same. :beer: -
agreed. Some times after a particularly difficult and long project, when i'm finally finished, I'll just sit there with a beer or two...
-
jssailem reacted to JamesG161's post in the thread Galvanic Corrosion/zinc depletion question. with
Like.
For a complete Guide look here. https://forums.sailboatowners.com/forums/sailboat-owners-guide-to-corrosion.292/ Jim... -
Ddlochner replied to the thread Sizing of exhaust lines and water lift mufflers.The specs say the exhaust outlet is 1.25". The exhaust hose should be 1.25" or 1.5". The engine needs some back pressure from the...
-
Ddlochner replied to the thread Hunter 29.5 tinted window replacements.Did you try the Hunter SBO store? They have a lot of Hunter parts. https://shop.hunterowners.com/hp/index.php
-
Ddlochner replied to the thread Cleaning the engine???.I've been using Presolve Orange Degreaser (Amazon link). It works really well with grease and oil.
-
Hello everyone After all that carpentry and more done on the boat, my Atomic 4 engine is very cruddy, what do you all recommend for... -
-
fred1diver replied to the thread Looking for ideas on dipstick extensions.Ok, time for a quick update. Here is what I ordered a while ago. The only issue is that the end fitting does not fit on the Atomic 4, so...
-
-
BigEasy replied to the thread Clean and wax.If you follow Maine Sail’s finishing protocol, you will get a great result. Lots of hard work; however, it’s worth the effort. No... -
Buff, Polish and Wax by Maine Sail https://forums.sailboatowners.com/threads/tips-for-a-great-buff-wax.117266/
-
Had some leftover decking from a few years back. Took some measurements, drilled some holes and used the bandsaw to cut out the slots...
-
JoeWhite replied to the thread Sizing of exhaust lines and water lift mufflers.I would remove ABS drain pipe and install exhaust hose made for this purpose. I do not believe the size of it is important as long as it...
