All Activity
-
JamesG161 reacted to BigEasy's post in the thread Galvanic Corrosion/zinc depletion question. with
Like.
Same here. Silver chloride test cell didn’t reveal any onboard problem; however, diver informed me that my prop blades were showing... -
JamesG161 reacted to jssailem's post in the thread Galvanic Corrosion/zinc depletion question. with Like.
There is the possibility that your boat is not the problem. A neighbor may be the cause. My diver places the used zinc’s on my boat...
-
JamesG161 reacted to BigEasy's post in the thread Galvanic Corrosion/zinc depletion question. with Like.
Purchased a test cell from BoatZincs a few years ago and purchase donut shaft zincs annually from them as well as drop (fish) zincs...
-
JamesG161 replied to the thread Transducer or Ballast Plug?.If your instruments are RayMarine, then a knot meter links to other instruments. Jim...
-
Depends on who makes the transducer. Most modern ones are made by Airmar. For example a plug for their common DST 800 is available at...
-
jssailem reacted to Davidasailor26's post in the thread Galvanic Corrosion/zinc depletion question. with
Helpful.
Battery isolator or isolation transformer? A battery isolator usually wouldn’t affect the current paths involved in stray current or... -
jssailem reacted to BAD ORCA's post in the thread Galvanic Corrosion/zinc depletion question. with Like.
I wish i had the room for an isolation transformer. They are not terribly expensive, just so little space left on a 36 ft boat after...
-
jssailem reacted to Maine Sail's post in the thread Lithium Battery Installation feedback requested with Like.
Isolated is typically used for RV trailers where there is no common ground. Non-Isolated is perfectly fine as all batts will typically...
-
Maine Sail replied to the thread Lithium Battery Installation feedback requested.Isolated is typically used for RV trailers where there is no common ground. Non-Isolated is perfectly fine as all batts will typically... -
cephius (Dave) replied to the thread Swim Ladder steps.Looks great. Will it still fold away? How will you store it when sailing? -
kappykaplan replied to the thread Clean and wax.Buff, Polish and Wax by Maine Sail https://forums.sailboatowners.com/threads/tips-for-a-great-buff-wax.117266/ -
CAVEAT: I ASSUME NO LIABILITY FOR YOUR USE OF THIS INFO! References follow this discussion: The MHW at East Pass (see reference) is .6... -
Had some leftover decking from a few years back. Took some measurements, drilled some holes and used the bandsaw to cut out the slots... -
-
smokey73 replied to the thread Lithium Battery Installation feedback requested.Thanks -
Ccolemj replied to the thread Help with mold/midew, ozone machine, bilge/locker cleaning.The issue of pH with chlorine dioxide isn't relevant. Although the gas is formed under highly acidic conditions, that acid is confined...
