All Activity
-
Prolly made the nuns look better, too. On the other hand it may be where the song “I Couldn’t Drink Her Pretty” came from. -
Ddlochner replied to the thread Steering linkage OD 23.Are you talking about a linkage between the rudder and the motor? When I had a small boat with an outboard, I did not use any linkage...
-
There's a VERY slight angle that's almost unnoticeable but it it bunching up at the top so I will adjust it. On my last boat, moving the...
-
Ddlochner replied to the thread PSS Shaft Seal….Salt Scale forming.The vent hose has a seeping leak, or more likely the seal is leaking when motoring and allowing a little water to spray between the...
-
Ralph Johnstone replied to the thread Funny Friday!!!.I will never be able to unsee that as long as I live :puke:. And from the way I feel right now, will be about a half hour after lunch. -
-
CCrazy Dave Condon replied to the thread Hunter 216 VARA Rudder Assembly.Call the forum store and ask for Mike Thomas. I recall bearings had to be replaced. @chuckwayne do yo concur?
-
Tally Ho replied to the thread Stinky hot water.I drain my tank annually by opening the drain cock and sticking the hose out of one of my scupper drain thru hulls (Mine exit above the... -
kappykaplan replied to the thread Furler line selection.:plus::plus::plus: -
Prolly made the nuns look better, too. On the other hand it may be where the song “I Couldn’t Drink Her Pretty” came from.
-
Don’t overlook the double pole service breaker located just to the inside aspect of the power cord inlet. Should have a clear waterproof... -
Smart Plugs don't have a thermal breaker inside them so you can rule that out. If resetting the AC breaker restores power the problem...
-
There can be only two sources causing the issue. It will be either External or Internal. You state the power cord light is on after the...
-
Rich Stidger replied to the thread Looking for Boarding Mat Suggestions.I needed a mat also, but just for foot traffic. I bought this mat from Amazon in a smaller size than you need... -
BigEasy replied to the thread Furler line selection.SailKote!
