All Activity
-
Davidasailor26 replied to the thread LFP for AGM Battery Swap.I agree - I didn’t mean to sidetrack us and broad brush all AI use cases as untrustworthy. I’ve seen it make unfortunate mistakes like... -
JamesG161 reacted to Crazy Dave Condon's post in the thread Is h260 forestay used without modification in jib furlers, usually? with
Helpful.
@Rick Webb Although the 26 and 260 are the same hulls there were some changes. The drum on the 26 used tangs secured to the anchor... -
JamesG161 reacted to Crazy Dave Condon's post in the thread Is h260 forestay used without modification in jib furlers, usually? with
Like.
The FF2 extrusion can be cut to fit any length to the forestay. The owners manual can be found under the hunter 260 boat information... -
JamesG161 reacted to Crazy Dave Condon's post in the thread Is h260 forestay used without modification in jib furlers, usually? with Like.
You’ll need to know the mast mfg.too. Look for mfg stickers on either the mast or boom
-
JamesG161 reacted to jssailem's post in the thread Is h260 forestay used without modification in jib furlers, usually? with Like.
These pages should be in your manual.
-
JamesG161 reacted to Crazy Dave Condon's post in the thread Is h260 forestay used without modification in jib furlers, usually? with Like.
@Joe See the above as I identified the further plus the manual should be posted under. Boat information under 260
-
JamesG161 replied to the thread P42 paralleling the buses on batteries.I can help you since my H430 is wired like yours. Jim...
-
Davidasailor26 replied to the thread LFP for AGM Battery Swap.That’s almost all. When dealing with Lithium Ampere Interrupt Capacity (AIC) matters too. AIC is the maximum amount of current that a...
-
CCrazy Dave Condon replied to the thread Is h260 forestay used without modification in jib furlers, usually?.@Rick Webb Although the 26 and 260 are the same hulls there were some changes. The drum on the 26 used tangs secured to the anchor...
-
Ccolemj replied to the thread Sanitary hoses.Yes, labor cost. It takes time to run PVC pipe on smaller boats (all of ours), even without the cabinets in place. Builders also get...
-
sailor832 replied to the thread P42 paralleling the buses on batteries.Are you using the inverter selection switch on the panel for the inverter to supply power to the AC system if so it could be that it is... -
Stu Jackson replied to the thread LFP for AGM Battery Swap.Let's to this yet again: 1. You size the wire based on the current and wire length (voltage drop) 2. You then size the fuse based on... -
jssailem replied to the thread How to tie a reef line to boom with a track?.I am unclear why the third reef cringle will not reach the reef horn. 1. Put your reef in early 2. Loosen the boom end of the reefing... -
Got to wonder why boat manufacturers don’t do this during assembly. Cost of PVC is a fraction of the cost of quality sanitation hose...
-
It is Imperial!:biggrin: