All Activity
-
william24424 replied to the thread Painting over molded non-skid deck.Yes, however, I have touched up paint every year. (1-2hrs each year) This has been easier than cleaning old non-skid, and less time. The... -
-
jssailem replied to the thread LFP for AGM Battery Swap.Phil. What is the short circuit rating of each of the batteries? In Parallel configuration that rating is cumulative. Your fuse will... -
-
Of course, the PFD wear rate is only about 10% if children and PWC are excluded. The tether wear rate is sub-percent. I've always... -
In support of @thinwater ’s suggestion, I have been using the idea of several tethers located on the boat rather than on my body for the...
-
The way I do it is a 1 gallon craftsman shop vac and a sponge. The shop vac comes in handy for so many things other than drying the...
-
I've done the same thing for a small sump pump (it does not actually dump into the sink, it tees into the pipe a few inches below that)...
-
correct.
-
I'm installing a pump that dumps into the sink drain. Since the drain is open, I assume no vent is needed?
-
-
Ddlochner replied to the thread More on the Catalina Acquisition.Here's a peek at the new Catalina 48. https://www.cruisingworld.com/sailboats/catalina-yachts-unveils-all-new-catalina-48/
-
john6206 replied to the thread Access to water heater ( C 320).yup. Eagerly awaiting delivery of Peggy’s book, because this boat seems to have all the odors. -
thinwater replied to the thread Vented loop necessary?.I've done the same thing for a small sump pump (it does not actually dump into the sink, it tees into the pipe a few inches below that)... -
You did not identify the size of your new House Bank. I am guessing there is more than a single new LiFePO4 battery in your house bank... -
google: spinlock deckvest pouch
-
There are cheaper sources for the bearings. Mauri Pro, Sailrite, and others sell the bags for $16. But there is nothing special about...
