All Activity
-
AArt12050 replied to the thread Teak upkeep.We’ve been using oil for many years with great results. It greys out over the winter, even under the shrink wrap. In the Spring, teak...
-
Went out for a sail today in the remnants of a small craft advisory. Seas were very lumpy at 2-4 feet and an occasional. 6-footer thrown... -
-
AWe often talk about whether or not the sailing tradition is alive and well and how it's a shame that kids these days bury their noses in...
-
Tally Ho replied to the thread New LFP House Battery.An update on my new LFP battery bank… I had communicated with the mfg (Humsienk) and they asked me to independently charge each battery...
-
-
Ddlochner replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.The end of the shaft is threaded, the threads are visible in the extreme close up photo you provided. A large gear puller, time, and PB...
-
Following up. Moving the shiv to the forward location solved the problem. -
Ralph Johnstone replied to the thread Removing Raymarine ST4000+ from Edson Destroyer Wheel — Need Guidance.ONLY if you are: - retired. - do little more than read the daily newspaper every morning. - do little more than yell at the local kids... -
Our club has a very active youth sailing program and we host several regattas each year. They also run a youth sailing camp each year... -
jssailem reacted to capta's post in the thread Need Help: Prop Shaft Jam Nut Won’t Budge with
Helpful.
Silicon bronze, NOT brass. If someone has been using brass instead of the more expensive silicon bronze, on a boat I was looking at, my... -
I had an issue several years ago where my helm pedestal was pulling out of the deck. Turned out the cockpit sole had rotted. We cut...
-
jssailem reacted to Davidasailor26's post in the thread Hunter 42 Passage Grounding wires in center bilge. with Helpful.
If the black wires were properly color coded they’d be either AC hot or DC negative. Neither of those should be connected directly to...
-
I assembled my water maker, after acquiring the high pressure pump. It took me several months of searching, but once I'd secured that...
-
capta replied to the thread Water maker in the Salish?.I assembled my water maker, after acquiring the high pressure pump. It took me several months of searching, but once I'd secured that... -
shemandr replied to the thread 1983 C&C Spreader Wobble.That seems pretty loose to me. What is the other side like? Assuming that the shroud is at normal tension I think the spreader should... -
Davidasailor26 replied to the thread Hunter 42 Passage Grounding wires in center bilge..If the black wires were properly color coded they’d be either AC hot or DC negative. Neither of those should be connected directly to...
