All Activity
-
JamesG161 reacted to Rich Stidger's post in the thread Hunter 410 Windlass Replacement with
Helpful.
You probably have an Anchorman 700 or 1000. If spare repair parts are needed, the only source I know is UK SL Spares . -
and finally Jim... aka Chemical Engineer -
jssailem reacted to Maine Sail's post in the thread Solar controller overcharging batteries with
Like.
Based on the design of the hetsink it is very outback looking, design wise .Having imported from Taiwan and Mainland for business I... -
FastOlson replied to the thread Running Backstays on my 1983 Beneteau First 35 removed if not sailing in high winds?.From the pix, it almost looks like your rig may have parrallel shrouds (i.e. with single lowers). Can you verify? Also, is the mast... -
That is exactly what I have done. The new one is working great and the old one which looks new is ready to be fitted if there is an issue.
-
jssailem replied to the thread Hunter 410 Windlass Replacement.Or he was clueless about your 410 and how they are wired. Clicking sounds often mean not enough power is being delivered to the motor...
-
Thanks for the tip.
-
Ddlochner replied to the thread Power at ignition On & Off.A know issue with Yanmar wiring harnesses is an intermittent failure in the wire powering the solenoid. The wire is a bit undersized and...
-
BigEasy reacted to Foswick's post in the thread Low-Stretch Halyards actually worth it for cruising? with Like.
I will say without much reservation that there is no point in Dyneema halyards unless you have high performance sails in good shape... -
Tally Ho replied to the thread Black smoke on start of my Hunter 28 (2GM20G Yanmar engine).I have a 2GM20F and I burn about 1/2 gallon per hour of motoring @ 3,000 RPMs. But check the top of your tank and look for some sort of... -
-
There should be a direct link (positive cables) from each battery bank to the 2 + posts on the ACR. Also, the alternator should be...
-
This is a great idea! Stick some epoxy into the chip, glue keelguard or a stainless plate over it, and go sailing knowing that one of...
-
Also, if you want to get real accurate on marking the tank level if you have a plastic fuel tank. Since the tank is probably not square...
-
Keep in mind that your fuel consumption will be highly dependent of variables, some of which you control, some of which you can't. Fuel...
-
jssailem replied to the thread Running Backstays on my 1983 Beneteau First 35 removed if not sailing in high winds?.Your mast image does not show the attachment at / near the mast head. This makes it difficult to identify the rigging lines on the boat...
