All Activity
-
smokey73 replied to the thread Fuel gauge location.Also, if you want to get real accurate on marking the tank level if you have a plastic fuel tank. Since the tank is probably not square... -
smokey73 replied to the thread Fuel gauge location.Keep in mind that your fuel consumption will be highly dependent of variables, some of which you control, some of which you can't. Fuel...
-
Ccolemj replied to the thread Help! Idiot Cracked My Gelcoat.This is a great idea! Stick some epoxy into the chip, glue keelguard or a stainless plate over it, and go sailing knowing that one of...
-
Ccolemj replied to the thread Low-Stretch Halyards actually worth it for cruising?.Even on a main halyard, many boats have active masts that will bend as the sail is tensioned or force increased. Or running rigging...
-
Joe replied to the thread Garmin GPSMap 276C - Worth Keeping?.I'm with Capta on this..... updating firmware and $30 for a new battery... no brainer. Back up is important. I would hardwire the... -
and finally Jim... aka Chemical Engineer -
Davidasailor26 replied to the thread Black smoke on start of my Hunter 28 (2GM20G Yanmar engine).In addition to Gary’s suggestions, keep a log of engine hours between refills. After a couple refills you’ll get a sense for how much... -
and finally Jim... aka Chemical Engineer -
and finally Jim... aka Chemical Engineer -
BigEasy reacted to SycloneDriver's post in the thread Black smoke on start of my Hunter 28 (2GM20G Yanmar engine) with
Like.
Does your boat have a hot water heater & is it heated with engine coolant? The coolant hoses going to the heater often need the air... -
If you have a plastic tank and can see the fuel in the tank. You can shine a flashlight in to the fluid portion and the level of fuel... -
-
jssailem reacted to Ward H's post in the thread Yanmar 2GM20F – Upgrade Raw Water Intake Seacock from ½” to ¾”? with
Helpful.
I upgraded from 1/2" to 3/4" thru hull for my engine water intake for a different reason. Hose barbs for 1/2" hose have smaller ID's... -
jssailem reacted to Allan12210's post in the thread Yanmar 2GM20F – Upgrade Raw Water Intake Seacock from ½” to ¾”? with Helpful.
Here is a link to a write-up I did a few years ago upsizing my raw water through hull to 3/4". I also upsized the hoses from the valve...
-
jssailem reacted to mermike's post in the thread Yanmar 2GM20F – Upgrade Raw Water Intake Seacock from ½” to ¾”? with Like.
3GM30F owner here. When I bought Tosca the diesel survyor said the 1/2" throughhull was undersized. When I redid my throughhulls a few...
