The standard Zinc will not fit on shaft. It is too thick between prop and boat. Had one on last year but the one at West Marine and Faucets will not fit. Any ideas?
..on my 29.5..Frankly, I always wondered how Hunter didn't noticed this fault in design...My solution is to saw them to a thinnerdisk , but to leave 2 mm free shaft for water to lubricate the cutless bearing..As it is , I have to replace them sooner,( I do it underwater also between haulouts) but no other choice... Make sure you put the right kind ( salt water or else).
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.