Yamaha 8, high thrust, NO STEERING?

[Mergatroid]

Just bought a h26 with a 2006 Yamaha 8hp, high thrust with throttle controls near the starboard stern rail seat. Previous owner just used the tiller, I want to link the two. But alas, can't get the darn thing to pivot. This model has no tiller or tiller controls. Therefore no tiller lock. Can't find a steering friction adjuster referred to in the manual, does not exist.Any experience or ideas?

 

[Tim Peoples]

Phillips Head Screw

Look on the shaft below the motor and controls. There is a phillips head screw that adjusts the friction. If it is completely tightened then the motor will not pivot. Loosen it a bit and the motor should pivot.

 

[Mergatroid]

Might be a little

thick.If the part of the motor that is facing the stern is 12:00, where is this screw?BTW, this model has noting at the 12:00. I did find a hex head about 6" down the shaft, port side. Looks like a possible.

 

[soling42]

Just happen to have one too. I'll ck

MergatroidI believe Tim means that the tension screw is around on the front(6:00?), sort of down from the choke knob. I'll look at mine tonight and post a photo.Tim, We're still in love with your "old" 260. It's been throughly pampered and put through the paces on more than a few trips. Lately it's been resting in the shop since summer lightening season began with a bang. The search is on for a fall dock space. We were getting spoiled at your spot. Hope all is well in your new location. Kelli sends her best.Michael

 

[soling42]

10mm socket on port side of pivot

Place a socket over the bolt head near the serial number plate at the pivot and you'll be able to tension or release it as necessary.Michael