G'day,I don't know if this forum is active but I'm ever hopefully. I am the proud Owner of a Bavaria Ocean 40, built in 2001. She is in very good condition apart from a few niggling water leaks.Does anyone else out there have a sililar problem:1) Window leaks. The cam type securing devises to the windows tend to turn around on themselves and do not clamp the window to the seal! Anyone know where to obtain new seals or cam locks?2) Does anyone suffer from, mostly fresh water so from the deck, ingress into the glassed in egg box construction just forward of the engine room. I keep getting water in there and can't find the source of the leaks?3) I seem to have a dribble of water ingressing from the chain plate connections with the deck. Water dribbles down the stainless steel tie rod which is attached to the shell.Without dismantling the chain plates I guess some kind of sealant run around the inside bolted base is the way to go.The rudder stock has about 2mm of play in the bearings. I asked Bavaria in Australia about this and they told it was OK. Anyone any experience with this?? Thanks and hope to hear from someone soon.