13 to 1 scope. Tis a bit beyond needed....Mini rant
Just returned from Block Island. Anchored next to a guy who put out 130 ft of chain in 10 ft of water at high tide.
Crowded anchorage? Don’t be that guy.
dj
13 to 1 scope. Tis a bit beyond needed....Mini rant
Just returned from Block Island. Anchored next to a guy who put out 130 ft of chain in 10 ft of water at high tide.
Crowded anchorage? Don’t be that guy.
13 to 1 scope. Tis a bit beyond needed....
dj
What were the current and forecast conditions? Have to consider the advisory reading material out there that recommends scopes of 10:1. Although it has also been pointed out that one gets a very small increment in additional holding power at scopes greater than 7:1. That is, holding power at 7:1 is effectively very near what you’d get at 10:1. So, there is rarely the need to deploy 10:1 in the practical setting, at least within protected anchorages and harbors. Moreover, with chain rode you can probably cut it down to 5:1. But if facing incoming seas a greater amount chain scope will dampen shock loads that the anchor might experience that could yank it out. It depends on the conditions, as always. But yes, such boaters are a nuisance in an anchorage when the conditions do not warrant that amount of scope (which is most of the time when boats are in it), IMO.Not quite 13:1 because the guy had about 4’ of freeboard at his bow. But regardless, 9:1 + was not called for.
![]()