Universal diesel engine wiring harness

Status
Not open for further replies.
jcb2

jcb2

.
Jun 5, 2012
51
Oday 31 Bayville, NJ
I have an O'Day 31 and just pulled my Universal diesel (M18) out to remove the prop shaft. In doing so I had a hard time with the wiring harness connector. It is extremely corroded and one prong actually broke off. I can buy a new harness for the engine but where does one get the matching connector to tie in the existing boat wiring?
 
D

Donnybrook

.
Apr 2, 2011
185
Catalina 27 Niceville, FL
I have a C27 with the M-18 and probably the same harness. I cut the plugs off by the engine and butt spliced the wires together. The plugs are more trouble than they are worth. You probably have another set of plugs by the instrument panel. I installed a terminal strip there so I could remove the panel without disconnecting each wire.
 
Status
Not open for further replies.

Top Bottom