I purchased a used Raymarine autopilot system, and the ST6001+ control head had been converted to flush mounting. One of the differences, I think, between surface mounting and flush mounting is that surface mounting requires three round holes - one big one, and two screw holes at the 11 o'clock and 5 o'clock positions; while surface mounting requires one big rectangular hole plus a molded clamping piece on the back.
Flush mount kits are available, but I can't seem to locate an "un-flush," or surface mount kit.
Does anyone know where I might get the piece or pieces I need to revert to surface mount?
Thanks,
jv
Flush mount kits are available, but I can't seem to locate an "un-flush," or surface mount kit.
Does anyone know where I might get the piece or pieces I need to revert to surface mount?
Thanks,
jv