Tuning the O'Day 222 (Stays)

Status
Not open for further replies.
Jun 3, 2004
16
Beneteau 381 Oceanis Harborage/St. Pete
Does anyone know what is the side stay tension should be for the inners and outers of a O'Day 222? One stay is from the top of the mast, the other is from the spreader. Any general rule of thumb? Thanks!
 
B

bruce cornell

general rule

tighten stays to about 10% to as high as 25% of working strength of the stay size/material. strength info in the west catalog. Center the mast and do both inners first, then both outers.
 
L

Lee

222 manual

sailortaylor, The manual for the 222 says to take all the slack out of the stays and to make sure the mast is centered fore / aft & starbord / port. Then, tighten the upper shrouds to handtight and take up the slack on the lower shrouds, not hand tight. Both lee side shrouds will go slack under sail. This lokks incorrect, but is, according to the original manual. DO NOT tighten the shrouds while under sail, doing so may cause too much tension and will damage the hull. The rig is designed to flex a bit. I was out on my 222 in 15 - 20 knot winds last week. I reefed the main and left the jib furled. The lee shrouds were very slack, but the boat handled fine. PS...I saw another boat lose its mast that day and another lose their outboard, bracket and all. The Hudson sure can kick up a fuss! Try to avoid the temptation to over tighten. Lee
 
Status
Not open for further replies.