trailer jack

[steve]

Can you fix a trailer jack on a 26x factory trailer or do i neeed to cut it off and replace it.

 

[Moe16696]

Ask the manufacturer...

Don't know about yours, but the jack on my X trailer is made by Shelby Industries.http://www.shelbyindustries.com/

 

[Lamar]

Steve, I have repaired the internal parts of my welded on 26d trailer jack. It is a pretty simple system. The problem I had was cranking the handle and the gears slipping or not engaging. The hard part was getting the trailer high enough to drop the intrenal parts out the bottom of the jack. What have you got to lose by trying?

 

[Ben]

Internal parts?

Hi Lamar,Where did you find the internal parts?

 

[Lamar/SavGa?26d]

Trailer Parts

Ben, I lucked out. My slippage was cause by a broken expansion pin. It goes though one of the gears, to hold it in place on the shaft. Home Depot, bolt and nut section. I think it was 75 cents. My jack is made by Fulton. There is one piece I need, that might have to come from Fulton. It is the "tab"(?) that slides in though the jack, at the top, and holds the assembly in place as you crank. I'll see if I can find it from Moe's Link (maybe they changed names) or a Fulton link. MacGregor Corp. may know the answer too. What do you need? I need a new wheel too.

 

[Lamar]

Fulton Trailer Parts Home Page

I could not gind a model # on my jack. I hope they can pull it up.