jsgonz --- do especially review that article on properly raising a dacron main:
http://forums.sbo.sailboatowners.com...d.php?t=120970 see post #1 this is 95% easiest way to control or lessen 'true' weather helm problems.
The following is quite advanced and relates to the
SHAPING of the mainsail, so I apologize if it makes one 'glassy eyed':
'Tensioning the luff on a boltroped dacron mainsail via the halyard will do two things simultaneously -
1. It will move forward the point at which the maximum draft occurs - reduces weather helm
2. It will cause the leech to 'open' or become more 'flatish' and with less tendency to hook-up-to-weather.
The combo of both above will result in 'faster' boat speed (in relatively flat water) with most of the 'roundness' closer to the luff ... the faster the boat the more important this SHAPE will be and the sail will be more stable (luffing) and be able to tolerate wider angles of attack (for less precision/accuracy needed by the helmsman) at the 'higher boat speeds' (eg. - when surfing or planing or getting up to near 'hull speed').
When beating, watching the mainsail's aft end of the leech to be mostly parallel to the boats centerline is quite important and also gives a visual indication of
correct or optimum mainsheet tension .... if you put in too much mainsheet pressure the leech will begin to hook up to weather and the boat will increase its amount of heel.
When beating especially, If the aft end of the leech (especially at near the area of the second-from-the-top batten) is not aligned
mostly parallel with the centerline of the boat and is 'pointing towards windward' .... youll get more weather helm (slower boat speed), plus increased heeling (for more weather helm PLUS increased skidding). Control the 'attitude' of the that #2 batten via mainsheet tension. Conversely, with insufficient mainsheet tension and the aft end of #2 batten is now pointing towards leeward, youll be 'falling off' the beat (faster but not pointing very well).
Suggest you aim to control the 'attitude' of that #2 batten with mainsheet tension (and vang tension), but only AFTER the luff has proper TENSION from the halyard which gives you 'basic' weather helm control/adjustment for 'todays' wind and wave states.
Additionally, over-tensioning the mainsheet to purposely 'hook up the leech' will allow 'power-pinching' (high lift at an
increased angle of attack during slower speeds - like putting down the wing flaps on an airplane.) The penalty when power-pinching is a 'tremendous' amount of heeling and increased skidding.
Its all too easy to apply too much tension to both the jib sheets and the mainsheet and totally distort the 3D sail shape .... which usually results in increased weather helm, skidding, and increased heeling. This is why racers prefer non-stretchy laminate sails and backstay tensioners. I still prefer dacron because its sooooo easy to adjust the SHAPE while underway.
hope this helps ;-)