teak and holly sole

[footerdog]

I am in the process of installing my new holding tank from Triple M, thanks all for the link to them. While the floor boards are all up I would like to lightly sand them down and redo them. Did Hunter use Dalys Seafin on them? Mine appear to have a varnish applied to them that is pretty scuffed up. Any suggestions on what to use will be greatly appreciated.

Thanks in advance
Frank Smith

 

[Rick D]

I Think So...

... but I switched to Helmsman Spar semi gloss when I did mine several times before putting a Lonseal floor in. When you look at the finish under the cabinetry, it certainty looks like Dalys.

 

[timvg]

We were told by Hunter a few years back that the Daly's profin was the original. We have redone our floors twice with the following and they come out looking phenominal.

http://www.dalyspaint.com/PDF/specs/S-ProFinGloss.pdf

We use the Gloss and they also have a less shiny Satin. (just depends on yoru preference). Each time, we have done 5 coats, lightly sanding in between each coat.

 

[Steve W]

HI, Frank, I don't have a floor refinishing answer for you but was curious where you're moored in OB? Are you with the Marine Center?

 

[footerdog]

I am at CA-39. OBMC places my mooring and I use there launch service. Hoping to be in May 1st. You?

About the sole, I am using Epifanes High Gloss clear varnish (laid down 4 so far, building to six) and two top coats of Epifanes rubbed effect varnish. I used this on my last boat. Held up great and was "tacky" when wet.

Thanks
Frank Smith