spreader

  • Thread starter Rafael Rodriguez
  • Start date
Status
Not open for further replies.
R

Rafael Rodriguez

Where could I get the spreader and it base for a hunter 23 from 1988. (ser #HUNA1374J788) The spreader has an angle of 25, thickness is 3mm, spreader ID is 31mm X 12mm, lenght is 35 inches in one side and 37"in the other side the cross section of the mast is 78mm by 107 mm the mast lenght is 29'and the spreader is 12'6'from the mast base. I already ask Rig-Rite and USSPAR but none of them gave to me the final solution yet Please help me I need my boat in the water!
 
G

Greg Stebbins

I to looked into replacing a spreader...

Rafael, I to looked into replacing a spreader about a year ago. No joy either. I seriously considered replacing the spreaders with oak. I still think it would have worked and, stained and varnished, looked great. Luck was on my side in that I was able to have the existing spreader welded. Greg H23 Faster-
 
J

Joe Matos

Si quieres te presto uno

Hola Rafa, actualmente tengo mi bote fuera del agua pq estoy haciendole unos arreglos estructurales y otras cositas esteticas... como tengo el mastil quita'o ando con los spreaders de mi bote (23 del '88) en el baul. bien podria prestartelo y que mandaras a hacer unos nuevos a la medida.., eso si, mi mastil es de 33 pies, asi que no se si son iguales los preaders..., chequiaste en Z-spars, tienen un site en el internet y son quienes suplieron a Hunter en estos botes..., dejame saber... jfm911@prtc.net
 
Status
Not open for further replies.

Top Bottom