Hi, I'm going to fly a asym crusing chute this season and I was wondering where I can get a masthead spinnaker bail. Looks like the masthead holes are about 3/8 in diameter and 13/4 on center. Should I just bolt in a stainless ubolt? Rich
- Status
I got a sheve from a place up in Canada
seven years ago for the Isomat ... Don't have that address anymore but the NG-28 Masthead Sheave Axle: NG1-6: or something like that. www.RigRite.com may work for you. There are slots in the crane these sheaves slip in for the Spin Halyards. Actually two slots. You would think you needed something more than an axle, but they work fine. Vic "Seven"
seven years ago for the Isomat ... Don't have that address anymore but the NG-28 Masthead Sheave Axle: NG1-6: or something like that. www.RigRite.com may work for you. There are slots in the crane these sheaves slip in for the Spin Halyards. Actually two slots. You would think you needed something more than an axle, but they work fine. Vic "Seven"
- Status