Sourcing Custom-Made Propane Hoses

[Snotter]

I am nearing the end of a 2+ year refurb of my Morgan 415 OI. With the launch date of my boat approaching, I would like to start on the design and installation of an exterior propane locker and regulator and hook up my old (but worthy) propane stove. Specifically I would like to use flexible gas hose between the locker and stove. However, I do not know of any sources for the custom-made hose and fittings; also, I don't know how to specify the fittings. It would be wonderful if the gray-beards on this site would recommend a reputable source for custom-made gas lines, and, perhaps, recommend where I can go to read up on the best practices for accomplishing my project.

 

[Rich Stidger]

In my city we have a welding supply company that will make up all kinds of hoses for all applications. They are my go-to for anything that is custom for propane. They have all the fittings, know what to use and where, and can crimp the ends properly. It is much more than just a propane refill location. Look in your local directory for welding supplies. Make a sketch of what you need with photographs of the stove input and tank, solenoid, gauge, etc, and have them design what you need and make everything to the correct length.

 

[Capt jgw]

Local industrial hose shop. Any decent sized city should have one or two around. I've used West Michigan Rubber here in Muskegon for propane and fuel lines. Made while I waited and only took a few minutes. Quality work and inexpensive.
All the fittings on my propane system are 3/8" flare which is a very common type used in all kinds of things. Yours are probably the same, but you can take the fittings you need to mate to into the shop to verify.

 

[JamesG161]

The folks will make one for you.
http://clarkgasco.com
The are in the business of Propane safety, near you.
Jim...

 

[NYSail]

I bought all new components including hose from defender a couple years ago. Have choice of hose length......

 

[Snotter]

Thanks all for the replies. JamesG161, there is a clarkgasco place near my home port. I will give them a try.

I would be interested in hearing recommendations for a good deck pass-through that I could use on LPG hose that has pre-installed fittings on both ends.

 

[JamesG161]

JamesG161, there is a clarkgasco place near my home port.

I use propane at my house, the local dealer will make it for you, to length and propane specs.
I did a propane distributor search for Rogersville AL and found them.
They are in the Propane Safety business! I am sure they have home (perhaps marina fuel dock service) refill or delivery to sell you their propane.

Tip: These companies will normally do a free safety inspection once a year!

Safety first!
Jim...