Soft, wet bilge, but I just want to sail...
- Thread starter jsherm
- Start date
here are photos of the affected areas. what you see is the filler used that was put onto the fiberglass bottom of the boat. the rotted mdf was placed on top of the filler. that stickup was then encased in more fiberglass. the bottom most photo shows a piece of the rotted mdf, next to a piece of the topmost fiberglass layer. all of the areas shown are on the port side of the boat. I am in the process of filling these areas by pouring epoxy into the voids. after that I will replace the inner liner pieces that were removed in order to be able to access the rot.