sink drain assembly 1" for a cal 27

[Gary Emrick]

This should have been simple. But now it's a quest. I have a stainless steel sink on board with a 1" drain hole. While attempting to replace the plastic drain tubing, I ended up replacing my thru hull fittings and valves as well. That was expensive enough. But now I've discovered that the 1" drain fitting that seats at the bottom of the sink bowl is corroded and leaking. I can't find a 1" drain/basket strainer fitting anywhere. Every one seems to only sell 1 1/2" drains. Any ideas? I don't want to have to replace the whole sink too. I'm sure they don't make that size anymore either. Help.

 

[reggie]

sink drain

try a supply store which specializes in wet bars.

 

[Gary Emrick]

Thank you

Thanks you. That is the perfect solution. I've looked everywhere. But I still have one problem. I had to hack saw off the old drain fitting that went through the bottom of the sink bowl. The old one was stripped and corroded. It also had non standard threads. I'm still looking for a chrome or stainless steel replacement for this sink drain fitting. Then I can use the bronze fitting you found for me to adapt to the plastic hose. I'm so close...and getting closer. Thanks again.