I would like to replace my Signet SL172 depth and SL267A digital knot meter housings and 1” pedestal mounts. These are not manufactured by Signet. I have googled suppliers without success. Can recommend a place to purchase?
Signet housings
- Thread starter stephen Penny
- Start date
- Status
Signet was my first call. They did not fabricate these. The boat manufacturer fabricated or had them custom made I was lead to believe per Signet. If unsuccessful in finding replacement housings my fall back plan is to take everything apart, sand, prime the bare areas and spray paint and re-install with a goal to make them look new again.
I could not find replacement Signet housings and pedestal support brackets. Therefore, I went ahead and sanded them down this weekend in place. I plan to prime and paint them next. I am hopeful the results will look as good as new.
Thanks for the input. I will check with them. Meanwhile I plan to prime and repaint tomorrow. If I like result I am done and ready to move on to my next project.
I contacted SignetMarine.com and they will repair/replace.
SL172 / Depth .............................388.00
SL267a / Speed ...........................388.00
All the old transducers will work with the new instrument heads!
SignetMarine.com
2315.5 Aresia Blvd.
Rodondo Beach
California, 90278
310.320.4349
But at $400.00 each I am going to go to a Combo GPS for less money and more functionality.
Rick
Jacksonville, FL
- Status