yeah = S2 comes with an anchor locker and that's it. No bow roller. I have a CQR I put in the locker and have chain and rope rode. Works well enough, but it's a pain to toss it under the bow rails and tie it off to the cleat off center. I put a bow roller on it, but it's not a very good solution for sailing with the anchor mounted on the bow. Basically it stays stowed until I need it and then have to wrestle it out of the locker and over the bow roller and same when retrieving. I want to put a more permanent solution together that will allow for quick deployment and easier retrieving of the anchor. I think the bow roller has to go out further, but I don't think I can extend one far enough out so that the end of the anchor will clear the anchor locker. I think I will have to put a hawse pipe into the locker door and a chain stopper in front of the hawse pipe to fix the anchor in place. Then I'm thinking about putting a winch on the foredeck just aft of the anchor locker to help winch the anchor up. A winch should be fine bc by the time I get the chain rode from the rope, the anchor should be free of the bottom and I can hand haul it form there. I single hand pretty much always so driving off the anchor isn't very practical. I am sure plenty of 9.2 owners have looked into this and have some creative solutions. Odd that most pics I see on line are NOT of the bow!