Replacement Rope Clutch for '83 Hunter 27

[SerenityTC]

I searched the forum without luck so posting here. I have an old EasyLock triple rope clutch that was originally manufactured by Sophus Berendsen. The handles on the clutch are broken and I have been looking for either a replacement unit or handles to no avail. I am curious if anyone else has run into this problem and if you were able to find a compatible model from another manufacturer. My first step was to check Garhauer but their units are a lot bigger than this unit and I would prefer to avoid drilling new holes in the deck.

I am attaching photos of the original unit. Any ideas would be GREATLY appreciated!! Thanks!

I have no idea why the photos are upside down.

 

[pvtpotter]

I searched the forum without luck so posting here. I have an old EasyLock triple rope clutch that was originally manufactured by Sophus Berendsen. The handles on the clutch are broken and I have been looking for either a replacement unit or handles to no avail. I am curious if anyone else has run into this problem and if you were able to find a compatible model from another manufacturer. My first step was to check Garhauer but their units are a lot bigger than this unit and I would prefer to avoid drilling new holes in the deck.

I am attaching photos of the original unit. Any ideas would be GREATLY appreciated!! Thanks!

I have no idea why the photos are upside down.

Try spinlock brand. I didn't install, po did. I think there is a direct fit unit.

 

[SerenityTC]

Thanks for the tip. I ended up going with Garhauer. I filled the old holes with epoxy and the new unit covers up the old "scars" so didn't have to worry about trying to match colors from the filler to the deck. It is my understanding there is an aluminum plate under the deck so I will need to tap the new holes prior to installation. Hope to get that part done over the weekend.

Try spinlock brand. I didn't install, po did. I think there is a direct fit unit.