I have refinished all of my teak except the coamings. How do you remove these? Can't figure out how to do it.
Thanks
Thanks
Removing cockpit coaming?
- Thread starter Cincy020
- Start date
It's going to depend on what they happen to be bedded with: but as a starter you might try some modest heat from a heat gun to help start the process -- light prying (Light! ) from a corner may reveal how much of what you might have to resort to- use a broad thin tool with as much surface area as possible: think 8" drywall knife.
When mine came off all four joints on both pieces essentially gave up-- but easily epoxied and repaired if necessary.
When mine came off all four joints on both pieces essentially gave up-- but easily epoxied and repaired if necessary.
Dynamite, pool acid, sawsall, I agree tape it off and finish by hand, saves trying to repair it when it comes off in chunks.
Thanks guys. So sounds like it is put on with adhesive versus a faster? I assumed a faster then was baffled when I couldn't find one!
