We are trying to find replacement parts for the recessed ceiling lighting in the cabins and salon. Prior to our buying the boat the lights had been switched to LED bulbs (from the original halogen we presume). The face rings of the fixture are an off white that nearly matches the ceiling panels throughout the cabins and salon.
We have pulled the fixtures and all we can identify on them is that they were made in Germany.
I have taken several photos of the fixture, and of the fixture cover (ring with glass) that are needing replacement. Those pictures are attached.
Any assistance you can provide to us is greatly appreciated.
Pictures:
This is a picture of the “damaged” ring that we are trying to replace…. notice the tabs are missing off the three prongs.
This is a picture of the front of the fixture pulled from the ceiling panel. At the top it says Made in Germany. At the left 12v 5W. On the silver, 0.15m.
This is a picture of the LED bulb that we are using (successfully) in the fixtures throughout the cabin and salon. I am holding a ring that has all three of the tabs on the prongs that hold the ring to the fixture. The tabs are inserted into the fixture and then twisted into place..
This is a picture of the back of the fixture. It reads LD1.10-1 And then there are five symbols below.
We have pulled the fixtures and all we can identify on them is that they were made in Germany.
I have taken several photos of the fixture, and of the fixture cover (ring with glass) that are needing replacement. Those pictures are attached.
Any assistance you can provide to us is greatly appreciated.
Pictures:
This is a picture of the “damaged” ring that we are trying to replace…. notice the tabs are missing off the three prongs.
This is a picture of the front of the fixture pulled from the ceiling panel. At the top it says Made in Germany. At the left 12v 5W. On the silver, 0.15m.
This is a picture of the LED bulb that we are using (successfully) in the fixtures throughout the cabin and salon. I am holding a ring that has all three of the tabs on the prongs that hold the ring to the fixture. The tabs are inserted into the fixture and then twisted into place..
This is a picture of the back of the fixture. It reads LD1.10-1 And then there are five symbols below.
Last edited: