Huh?
First, I am no expert. What I suggest is just "what I do". It may or may not be the "right way", but it works for me.I am not sure I understand what you are asking. My C22 doesn't like to stay in irons without some attention, but why do you need to put her in irons to raise the jib?I figure you can raise the jib on any point of sail. If I need a stable state that requires no attention from me I heave to, but that requires that the jib is up, at least the way I do it (Is it possible to heave to with main only?).Do you mean that you want to go forward to hank on a jib? If so, why not do that before you raise the main?The only reason I can think of to need to hank on a jib after the main is up is if you decide to change jibs because the conditions changed. In that case, and in a non-racing context, I probably would drop the main to do it. It really isn't a big deal and I bet it only takes me about 4 minutes to be back underway, if I don't dally. If it is blowing too hard for the jib I am flying, I usually just go to main only rather than bother to put on a smaller jib in those conditions.My method for getting underway when single handing is a follows: 1. Hank on jib, remove covers, and attach halyards while still at the dock. 2. Motor out of marina. 3. Head up with motor idling and tiller tied. 4. Take ties off of main and raise main quickly. 5. Start sailing with only main. 6. Kill and raise motor. 7. Raise jib with sheets loose. 8. Adjust jib sheet. 9. Have a wonderful day sailing!Steps 2-8 take a total of maybe 2 minutes.All of this may be tougher if you don't have halyards lead back to the cockpit, but I wouldn't even consider not having the halyards lead aft as well as having a downhaul for the jib. These two things make life much easier even if you don't singlehand.If I misunderstood what you are asking, please clarify the question and I will try again.Pete