Pulling a Hunter 380 out this June

[planoron]

Well we will be in Greece sailing the islands for 3 weeks and I am having our 380 pulled out while we are gone. My list is:
* new bottom job (not really needed yet but while its out...)
* new anodes
* topsides buffed and re-striped with the new name
* coachroof waxed and buffed out
* check over the throughhulls

So I am just checking to see if there is anything i might be missing while shes out. We will probably sell and move up before she needs pulled again.

 

[Ralph Johnstone]

Check the cutlass bearing for play.

Clean the prop.

If the depth transducer is a thru-hull, lightly sand the face and repaint with water based anti-fouling paint.

 

[mz4wheeler]

When you first pull it out, before anything else, find the blisters (there WILL be some) and clearly mark them with white chalk/tape. Mark the center of each blister. The blisters will shrink very fast, and disappear, but they are still there. A good surveyor will find them. Once you identify all of them drill them out and use this sitting time to allow them to dry out. Repair, repaint.