Oh Joy Resto 04/03/10

Status
Not open for further replies.
C

CharlieCobra

.
May 5, 2006
1,140
Knutson K-35 Yawl Bellingham
It's been a while since I've touched Oh Joy because of the paying boat. However, ya can't sand outside in the rain so we worked on the old girl Friday and today. We set in the sister to that bad rib aft and I put the fasteners to it today.



I still have to clean it up.



Talk about a PITA. Getting these in from here was a real one... The boys were working on getting the hull down to the barrier coat.



They're making progress.



Hopefully, next week the weather will improve. I'd like to get the Valiant done.
 
Ross

Ross

.
Jun 15, 2004
14,693
Islander/Wayfairer 30 sail number 25 Perryville,Md.
Charlie , I hope that you have a good bit brace. Those are big, long screws.
 
C

CharlieCobra

.
May 5, 2006
1,140
Knutson K-35 Yawl Bellingham
Nope. I have a Rigid impact driver with 700 in lbs of torque, a two foot long screwdriver with a square shank and a crescent wrench. It works well enough to twist a #20 screw off if I get too rambunctious.
 
Ross

Ross

.
Jun 15, 2004
14,693
Islander/Wayfairer 30 sail number 25 Perryville,Md.
CharlieCobra said:
Nope. I have a Rigid impact driver with 700 in lbs of torque, a two foot long screwdriver with a square shank and a crescent wrench. It works well enough to twist a #20 screw off if I get too rambunctious.
Click to expand
That may be the only tool better than a bit brace for turning those big screws.
 
Status
Not open for further replies.

Top Bottom