Not bad for a monohull

Status
Not open for further replies.

higgs

.
Aug 24, 2005
3,736
Nassau 34 Olcott, NY
Just checked the volo site. and ABN Amro one has just clicked off a record 538 miles in 24 hours. It must be quite a ride at over 20knots average. Ayone know the record for a multi-hull? http://www.volvooceanrace.org
 
J

Joe Westermeyer

Leaking, hull-to-deck

In this last year we've had new appearance of leakage at areas where deck is riveted to hull. Recommendation is to remove all rivets, rebed the joint, and replace rivets with screws. Cost will be $9,000. Any experiences with similar problems? What did you do?
 
R

rich cooper

mutihull records

Steve Fossett and Playstation crew - Transatlantic record An 11-yr. old west to east transatlantic record, from Ambrose Light Tower, New York, to Lizard Point in SW England was handily broken by Steve Fossett and the crew of Playstation in October 2001. The 125 ft. maxi-catamaran, Playstation, broke the old record of 6 days, 13 hours and 3 minutes by over 40 hours. They crossed the Atlantic with an average speed of 25.78 knots in 4 days, 17 hours, 28 minutes and 6 seconds. Commanders' Weather was in daily contact with Stan Honey of the Playstation crew beginning in September 2001 with a synopsis of Atlantic weather pattern and the possibility of a record breaking crossing. Finally, at the beginning of October 2001, the weather pattern began to shape up for the record attempt. The meteorologists at Commanders' Weather were responsible for the weather forecast and suggested routing for the great Maxi as it made it's way across the Atlantic. In addition, Playstation travelled 687.17 nautical miles in a 24-hour period, averaging 28.63 knots, breaking the old record set by Club Med of 655.13 nautical miles in February 2001. CONGRATULATIONS to the Playstation crew for a historic effort and a fantastic record breaking voyage. For more information, link to http://www.fossettchallenge.com. -------------------------------------------------------------------------------- --------------------------------------------------------------------------------
 
C

Capt Ron;-)

The Joint

*cry The hull to deck joint is structural and an important part of hull integrity. Rivets nor screws are good here, but rivets are fairly easy to drill-out. Find a people-friendly yard and do it yourself. Bolt it together with liberal amount of 5200 and nylock nuts and washers. Nail that sucker down, and save some cash. No one will do a better job on your boat than you will yourself. Somethings you can't do, but this is not rocket science.
 
Status
Not open for further replies.