A week or so ago you asked about zincs for the end of the prop
shaft. Yes, one can be placed there. It is round, like a very
short cylinder, with a hole in the middle and the forward side shaped
to fit the rear of the prop assembly. It is held on by the bolt
that goes into the prop assembly from astern, plus a washer.
I used such zincs when I had the combi system. They can perhaps
still be purchased from Steve Birch in U.K. or Vega Marin AB in
Sweden. I bought mine from Vega Marin. Best way to contact them is
by fax, see old message number 2334 or 1342, they are still in
business by fax and mail order.
John Salt Spring Island, B.C., Canada V 1492
shaft. Yes, one can be placed there. It is round, like a very
short cylinder, with a hole in the middle and the forward side shaped
to fit the rear of the prop assembly. It is held on by the bolt
that goes into the prop assembly from astern, plus a washer.
I used such zincs when I had the combi system. They can perhaps
still be purchased from Steve Birch in U.K. or Vega Marin AB in
Sweden. I bought mine from Vega Marin. Best way to contact them is
by fax, see old message number 2334 or 1342, they are still in
business by fax and mail order.
John Salt Spring Island, B.C., Canada V 1492