New Control Handles

[rpell1@msn.com]

Hi all,

Before I go tearing things apart again, so that I might "fix" a problem, I thought it might be a good idea to ask first.

I am changing out my standard vinyl engine control handles to the shiny stainless type. The new throttle handle is fine but, the new shifter handle does not have enough forward throw to engage forward gear. It is stopped by the vertical part of the pedestal rail and does not move forward enough, as does the vinyl handle which is shorter, to engage forward gear.

I am hoping that this is resolved by adjusting the cable length at the control handle end in the pedestal??? From previous experience, I know that the handle shaft and extension arm are one piece and the only adjustments that can be made are at the cable ends.

Any suggestions?

Thanks all and Happy Sailing

 

[LuzSD]

we had the exact same situation and yes, as you described, we adjusted it at the other end. I go right up against the pedestal in forward, but it goes far enough.

 

[rpell1@msn.com]

Thank you. Now my job has become very easy...............I hope!

 

[csavage]

another option is to bend the handle; it's not that hard to do and is effective.

 

[Glenn17467]

Adjust cable first and still go ahead with the lever replacement. A friends C30 had the same problem Saturday, it would not go fully into forward. I have replaced the delrin bushing at the lever which solved a hard to move control.