New 216 owner with missing parts

[Subzero]

Hello, first time poster here, happy to join the forum. We bought a 2008 216 to use at our lake house on lake Aylmer, Canada. The boat is in decent shape and the sails are like new, but the boat is missing several parts for which I would need help with the specs. More specifically:

- Diameter and length of the following clevis pins:
- Gooseneck
- Upper and lower pins on Harken furler spool
- Mast step (is it even a clevis pin or is it a bolt or something else?)

- Mast stop (make and model ideally or is it flat or round? size? etc.)

- Boom vang blocks (make and model)

- Tiller extension make and model

Thanks in advance. I'm sure there will be more question.

(tried to attach a picture but getting "Oops we ran into a problem").

 

[kappykaplan]

Welcome to the forum!
You may find some of the information you seek in the Hunter 216 Downloads section on this site.

HunterOwners.com downloads

HunterOwners.com downloads

hunter.sailboatowners.com

There is additional information (Owner Mods, Reviews, etc.) here:

Hunter resources, by model

Hunter resources, by model

hunter.sailboatowners.com

 

[Subzero]

Thank you. I had already browsed that content but did not find the information I'm loking for.

 

[fred1diver]

Lake Aylmer as in Aylmer Qc?
If so, look at the chandlery in Ottawa
If you have access to a caliper you can measure the size you need.
Tiller extension, use whatever you like, same for the blocks, see what you want and need

 

[Subzero]

No, about 450km east of there in Stratford QC. No chandleries around here, I'll need to order online.

 

[Subzero]

I found the vang blocks in the manual (Harken 094 and 085).

 

[abouttime]

A good way to determine the size of a missing clevis pin is to use a set of drill bits. The largest bit that fits the hole is the size you need.