Need the brass bushing for ST1000 autopilot

[peterbud]

I am in the process of moving my Raymarine St1000 autopilot to a different boat and need the bushing that goes into the seat. Part #D002. I dont want to buy the 5 pack unless I have to knowing I will never use the other four. If anyone has an extra one it would be appreciated. I will pay for it.

Thanks

 

[Ray Bowles]

Go to your local fastener store. They stock every type of bolt, nut and fastening devise know to man and probably your bushing. You will need the dimensions of the original part. Od., Id., Height. Most bushings are standard size. If they don't have it they will know where to get one.
Ray

 

[Ross]

There is always McMaster-Carr

 

[Roger Long]

Damn. I have two but they are in my storage unit in Portland, Maine and I'm in Solomons, MD.

I might be going to Portland in a week or so if there is going to be any delay on my engine repair so let me know if you don't find one. This is the tiller pilot, right?

I have a bunch of spares including a whole main unit I carry in case of failure as I depend on it heavily. I didn't use the bushing iin my installation.

 

[peterbud]

Roger it is the tillerpilot st1000. It is my spring list so there is no major rush.

 

[RichH]

Go to your local fastener store. They stock every type of bolt, nut and fastening devise know to man and probably your bushing. You will need the dimensions of the original part. Od., Id., Height. Most bushings are standard size. If they don't have it they will know where to get one.
Ray

If not a 'fastner shop' any 'bearing supply shop' will have them. Take your tiller pilot along to ensure the 'slide fit'.