NAVMAN 3100 Depth Display

[sailnoproblem]

I have a Navman system wind display and a depth display. OK I know that's too bad.
My problem is with the depth display. While at anchor it reads the depth fine, most of the time, but under way it's slow to read and most of the time there is no display at all.
There is no replacement available. I don't want to spend the $ on a new system.
Does anyone know of a repair shop, or any suggestions that can help?

 

[Sailor Sue]

Google "Indigo Electronics" or "zebra connectors on Navman"
There was a gentleman named Tom selling replacement connector strips with complete instructions. Don't remember the exact cost, but I think it was under $50 for one instrument. For an additional cost you could send your instruments to him and he would do the repair. It wasn't particularly difficult and my Multi is still working like new over a year after the repair.
I don't know if this address is still good but you can try:
tom@atomicfourdotcom
Switch the "four" to "4" and change the "dot".
I hope Tom is still around and can help you out. Despite their problems I think the Navman's had nice features.

 

[sailnoproblem]

Google "Indigo Electronics" or "zebra connectors on Navman"
There was a gentleman named Tom selling replacement connector strips with complete instructions. Don't remember the exact cost, but I think it was under $50 for one instrument. For an additional cost you could send your instruments to him and he would do the repair. It wasn't particularly difficult and my Multi is still working like new over a year after the repair.
I don't know if this address is still good but you can try:
tom@atomicfourdotcom
Switch the "four" to "4" and change the "dot".
I hope Tom is still around and can help you out. Despite their problems I think the Navman's had nice features.

Thank you Sue. Yes Tom is there and can help. His Email is thomas.stevens@cox.net
Thanks again and best regards,
Frank