Hello,
I am looking for someone who might have some knowledge about Nautech 3000 Analog system. I know this is an older model but until recently it worked perfectly. The issue is when I put the control head into the SET mode it illuminates the GREEN light and I cannot get that to extinguish or go to RED. Normally, I would place the control head in SET and rotate the compass card until the Green light goes out, then hold the knob in the center and match the compass card to the actual heading. It has suffered no real moisture as the pedestal is covered with water resistant material, and the bimini is always up. Any thoughts?????
I am looking for someone who might have some knowledge about Nautech 3000 Analog system. I know this is an older model but until recently it worked perfectly. The issue is when I put the control head into the SET mode it illuminates the GREEN light and I cannot get that to extinguish or go to RED. Normally, I would place the control head in SET and rotate the compass card until the Green light goes out, then hold the knob in the center and match the compass card to the actual heading. It has suffered no real moisture as the pedestal is covered with water resistant material, and the bimini is always up. Any thoughts?????
