Mixing elbow for 3HM35F

Status
Not open for further replies.
Gaditano15920

Gaditano15920

.
May 2, 2007
8
Hunter 37.5 Cobb Island MD
Does anyone have a a good link or know where I can get a mixing elbow for the Yanmar 3HM35F...been looking for the past hour online with no luck. Would also love to know what the parts number are since I dont own a parts catalog. Was enjoying the day motor sailing (2kt winds)and noticed two much smoke coming from the rear and bogging with the engine. I know the bottom and prop should'nt have been the problem since I just recently floated here. Finally saw smoke coming from the engine compartment...one half of the mixing elbow sheared itself off the coupler and there was water coming in from the exhaust and to much drama for the 4th of July...not to mention having to limp back to the marina in 90 plus heat at 1 kn. Any leads would be appreciated...thanks all!
 
BobM

BobM

.
Jun 10, 2004
3,269
S2 9.2A Winthrop, MA
You must not be using google...

One minute flat. I have bought from Torrenson before and they are awesome. Customer service is great and when they had something on a 3 day backorder they called me and asked me whether to split the shipment. BobM
 
BobM

BobM

.
Jun 10, 2004
3,269
S2 9.2A Winthrop, MA
No luck...

...try the main site and then run a search or plug "3HM35F elbow yamar" into google.
 
BobM

BobM

.
Jun 10, 2004
3,269
S2 9.2A Winthrop, MA
PN according to Torrenson...hmm they list two

Category:Engine Parts & Accessories > Yanmar Engines and Parts Manufacturer: Yanmar Part Number: 128370-13530 Description: ELBOW, MIXING Our price: $145.29 - each Category:Engine Parts & Accessories > Yanmar Engines and Parts Manufacturer: Yanmar Part Number: 124070-13520 Description: ELBOW, MIXING Our price: $167.63 - each Why two? Don't know. I'd give them a call were I you. Good luck, Bob
 
J

jimq26

.
Jun 5, 2004
860
- - -
The name is Torresen - not the name you are using.

Torresen Marine, Inc. - Marine Diesel Direct
 
Gaditano15920

Gaditano15920

.
May 2, 2007
8
Hunter 37.5 Cobb Island MD
Thanks Bob

Thanks for the help...I got to the site earlier on but as you mentioned it provides two different parts...dont know if this is the top AND bottom but I will call to make sure
 
Joseph Shirley

Joseph Shirley

.
Jun 13, 2005
559
Irwin Barefoot 37 CC Sloop Port Orchard WA
There are two different mixing elbows for that engine.

One is shaped like a long bent pipe (30 degrees or so) with a hose barb entering after the bend, and I believe this one is the standard. The other is a shorter elbow shaped like an inverted U which is the kind I have. If you just tell the parts guy which one you have they will supply it. Remember the U shaped mixing elbow is connected to the exhaust elbow by way of a union fitting which turns one way to tighten both ends. It has a right hand thread on the bottom and a left hand thread on the top . thus the thread on the pipe thread end of the mixing elbow is left handed. I'd give you the part numbers if I had them, but my manuals are on my boat. Good luck Joe S
 
Status
Not open for further replies.

Top Bottom