I had my max prop classic reconditioned this winter and re-installing was fairly straightfoward. However, if I tighten the hub bolts more than hand snug, the blades are wicked stiff and don't open when rotating shaft. The prop is greased, and installed correctly I believe. Searched internet and not much info on how tight to make these bolts. The one thing I did notice is that there is 2-3 threads of shaft showing after I tighten the nut, and PSI says two is the max.. so wondering if that could be part of it? Or is it ok to just have the bolts snug tight on the hub and installed witht eh cotters properly?
Thanks in advance for any sage advice
Sean
Thanks in advance for any sage advice
Sean